The trucks your operation runs.Not the production equipment.
On-highway and vocational trucks for oil and gas operations. We're specific about the boundary because guessing at scope wastes your time.
- 48 hrs
- Inspection results, from the unit landing in the bay
- 24 hrs
- Written estimate, parts and labour broken out
- 40,000 sq. ft.
- Edmonton facility with overhead cranes
Proof of capability
Capability you can check before you commit
Mach 6 is an authorized CVIP inspection station and Sennebogen's authorized service provider, working out of a 40,000 sq. ft. Edmonton facility with overhead cranes, a dedicated heavy-duty alignment bay and the diagnostic tooling to confirm a fault instead of guessing at it.
Authorizedservice provider
Distributor
Authorizations, distributor lines and safety certifications Mach 6 holds
What Mach 6 handles
Oil & Gas Fleets at Mach 6
- On-highway and vocational trucks in an oil and gas operation
- CVIP inspections and compliance documentation
- Engine, driveline and chassis repair
- Hydraulic systems on vocational bodies — picker, vac and service trucks
- Preventive maintenance scheduled around field rotations
- Mobile support around Edmonton and area
How the process works
Four steps, same order, every time
Same sequence whether it's one unit or a fleet program — that's what makes the 48-hour and 24-hour commitments something we can actually hold.
Walk your fleet with us
Unit list, duty cycles, current intervals and the failures that keep repeating. No program without that first.
Build the schedule
Service intervals mapped to how the units actually run, sequenced so you never lose two trucks the same week.
Run the program
Digital inspections, photo approvals and one point of contact who knows your fleet by unit number.
Review and adjust
We bring the data back: what failed, what caught it early, what the interval should be next cycle.
Every job leaves here with a record: what was inspected, what was found, what was approved and what was done. That record is what turns a repair into a maintenance history you can plan against.
Do you service oilfield production equipment?
No. This page covers the trucks the operation runs — on-highway and vocational units. Production equipment is outside our scope and we'd rather say so up front.
Get it booked
Tell us what's down.
We'll tell you when it's back.
Inspection results in 48 hours. Estimates in 24 hours. Both start the moment the unit lands in the bay.
Fastest route if the unit is already down
Edmonton, AB T6E 0T3