780.440.1723 6405 75 Street NW, Edmonton
Mach 6 Heavy-Duty
Request Service
Mach 6 technicians at the diagnostic tool chest in the shop
Confirmed capability

Intermittent faultsget found here.

Starting and charging through to module communication and the wiring fault that only shows up in the cold. Electrical work rewards tooling and patience, and we bring both.

B Call 780-440-1723
48 hrs
Inspection results, from the unit landing in the bay
24 hrs
Written estimate, parts and labour broken out
40,000 sq. ft.
Edmonton facility with overhead cranes

Proof of capability

Capability you can check before you commit

Mach 6 is an authorized CVIP inspection station and Sennebogen's authorized service provider, working out of a 40,000 sq. ft. Edmonton facility with overhead cranes, a dedicated heavy-duty alignment bay and the diagnostic tooling to confirm a fault instead of guessing at it.

SennebogenAuthorized
service provider
BOSS Air/PowerDistributor
Certificate of Recognition (COR)
Alberta Construction Safety Association

Authorizations, distributor lines and safety certifications Mach 6 holds

What Mach 6 handles

Electrical Diagnostics at Mach 6

  • Starting and charging system testing under load
  • Wiring, harness and connector fault tracing
  • Network and module communication faults, including no-comm conditions
  • Sensor and actuator diagnosis against live data
  • Lighting, accessory and aftermarket install faults
  • Intermittent and cold-start-only complaints documented as they're reproduced
Close view of diagnostic work being carried out on a heavy-duty unit

How the process works

Four steps, same order, every time

Same sequence whether it's one unit or a fleet program — that's what makes the 48-hour and 24-hour commitments something we can actually hold.

  1. Tell us what's down

    Call the shop or send the service request. We take the unit, the fault, and how fast you need it back.

  2. Diagnose before we quote

    Computer diagnostics and a full inspection come first. You get photos of what we found, not a verbal guess.

  3. Estimate inside 24 hours

    Written estimate with parts and labour broken out. Nothing else gets touched until you approve it.

  4. Back on the road

    Repair, retest under load, and a digital record of the work that lands in your maintenance file.

Every job leaves here with a record: what was inspected, what was found, what was approved and what was done. That record is what turns a repair into a maintenance history you can plan against.
Mach 6 process commitment
Placeholder — needs client inputCustomer proof. The Website Plan calls for a customer-outcome block on every commercial page. No named customer references, testimonials or case results appear in the supplied documents, so nothing has been invented. Supply an approved quote with permission to publish and it drops into this block.
Another shop couldn't find it. Will you?

That's most of what this page is for. We charge for diagnostic time and we document what we ruled out, so you're not paying twice for the same guess.

Do you do module programming?

Diagnosis, module and sensor replacement and the software work that goes with it are part of the job. Tell us the unit and the fault code and we'll confirm scope before you book.

Get it booked

Tell us what's down.
We'll tell you when it's back.

Inspection results in 48 hours. Estimates in 24 hours. Both start the moment the unit lands in the bay.

B Call 780-440-1723
780.440.1723
Fastest route if the unit is already down
6405 75 Street NW
Edmonton, AB T6E 0T3