780.440.1723 6405 75 Street NW, Edmonton
Mach 6 Heavy-Duty
Request Service
Highway trucks from a logistics fleet inside the Mach 6 shop
Priority service

Highway fleets run ondecisions made fast.

For a carrier, the repair is rarely the problem — the wait for a number is. Estimates in 24 hours, inspection results in 48, and a maintenance record you can actually audit.

D View Fleet Resources
48 hrs
Inspection results, from the unit landing in the bay
24 hrs
Written estimate, parts and labour broken out
40,000 sq. ft.
Edmonton facility with overhead cranes

Proof of capability

Capability you can check before you commit

Mach 6 is an authorized CVIP inspection station and Sennebogen's authorized service provider, working out of a 40,000 sq. ft. Edmonton facility with overhead cranes, a dedicated heavy-duty alignment bay and the diagnostic tooling to confirm a fault instead of guessing at it.

SennebogenAuthorized
service provider
BOSS Air/PowerDistributor
Certificate of Recognition (COR)
Alberta Construction Safety Association

Authorizations, distributor lines and safety certifications Mach 6 holds

What Mach 6 handles

Trucking & Logistics Fleets at Mach 6

  • CVIP inspections at an authorized station, scheduled around your runs
  • Preventive maintenance programs mapped to real duty cycles
  • Engine, driveline and chassis repair under one roof
  • Alignment and tire-wear control as a running cost, not an afterthought
  • Digital inspection history per unit number for compliance and resale
  • One point of contact who knows the fleet
Mach 6 technicians walking the shop floor between service bays

How the process works

Four steps, same order, every time

Same sequence whether it's one unit or a fleet program — that's what makes the 48-hour and 24-hour commitments something we can actually hold.

  1. Walk your fleet with us

    Unit list, duty cycles, current intervals and the failures that keep repeating. No program without that first.

  2. Build the schedule

    Service intervals mapped to how the units actually run, sequenced so you never lose two trucks the same week.

  3. Run the program

    Digital inspections, photo approvals and one point of contact who knows your fleet by unit number.

  4. Review and adjust

    We bring the data back: what failed, what caught it early, what the interval should be next cycle.

Every job leaves here with a record: what was inspected, what was found, what was approved and what was done. That record is what turns a repair into a maintenance history you can plan against.
Mach 6 process commitment
Placeholder — needs client inputCustomer proof. The Website Plan calls for a customer-outcome block on every commercial page. No named customer references, testimonials or case results appear in the supplied documents, so nothing has been invented. Supply an approved quote with permission to publish and it drops into this block.
Can you keep our whole fleet compliant?

CVIP inspections are done here at an authorized station, with repairs and re-inspection in the same visit and NDT coordinated where it's needed.

Get it booked

Tell us what's down.
We'll tell you when it's back.

Inspection results in 48 hours. Estimates in 24 hours. Both start the moment the unit lands in the bay.

D View Fleet Resources
780.440.1723
Fastest route if the unit is already down
6405 75 Street NW
Edmonton, AB T6E 0T3